Emg

(i) Remove the bearing caps with the lower bearing and thrust washers (No.3 cap only). (See procedure la) and (b) above)

(j) Measure the Plastigage at its widest point. Standard oil clearance:

(0.0005 - 0.0021 in.) Maximum oil clearance: 0.10 mm (0.0039 in.) Undersized: U/S 0.25

NOTE: If replacing the cylinder block subassembly, the bearing standard clearance will be:

If the oil clearance is greater than maximum, replace the bearings. If necessary, grind or replace the crankshaft.

(k) Completely remove the Plastigage.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment