Inspect Fuel Pressure

(a) Check the battery voltage above 12 volts.

(b) Disconnect the cable from the negative O terminal of the battery.

(c) Disconnect the cold start injector connector.

(d) Put a suitable container or shop towel under the cold start injector pipe.

<e) Remove the two union bolts, four gaskets and cold start injector pipe. NOTE: Slowly loosen the union bolt.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment