Install Cylinder Head Cover

(a) Apply seal packing to the cylinder head as shown in the figure.

Seal packing: Part No.08826-00080 or equivalent

(b) Install the gaskets to the head covers.

(c) Install the two head covers with the four washers and cap nuts.

(d) Install the gasket to the center cover.

le) Install the center cover with the four bolts.

10. INSTALL NO.2 AND N0.3 TIMING BELT COVERS

(a) Install the gaskets to the belt covers.

(b) Install the No.2 and No.3 belt covers with the seven bolts.

NOTE: Each bolt length is indicated in the figure.

11. INSTALL WATER PUMP PULLEY AND DRIVE BELT

12. INSTALL WATER OUTLET AND BY-PASS PIPE

(a) Install a new gasket, the water outlet and by-pass pipe assembly with the three bolts

Torque:

Cylinder head side

280 kg-cm (20 ft-lb. 27 N-m) Cylinder block side

(b) Install the alternator drive belt adjusting bar with the three bolts.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment