Check Harness And Connector Gateway Ecu Component Shown By Subcode

HINT:

• Start the check from the circuit that is near the component shown by the sub-code first.

• For details of the connectors, refer to "TERMINALS OF ECU" (See page NS-26).

(a) Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the gateway ECU and the component shown by the sub-code. (1) Disconnect all connectors between the gateway ECU and the component shown by sub-code.

(2) Check for an open or short in the AVC-LAN circuit between the gateway ECU and the component shown by the sub-code. OK:

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment