Garage door opener

Indicator light

Indicator light


The garage door opener (hQineLinh" Universal Transceiver) is manufactured under license from HomeLink" and can be programmed to operate garage doors, gates, entry doors, door locks, home lighting systems, and security systems, etc.

(a) Programming the HomeLink" The HomeLink" in your vehicle has 3 buttons and you can store one program for each button.

To ensure correct programming into the HomeLink", install a new battery in the hand-held transmitter prior to programming.

The battery side of the hand- held transmitter must be pointed away from the HomeLink" during the programming process.

For Canadian users, follow the procedure in "Programming an entrance gate/Programming all devices in the Canadian market".

1. Decide which of 3 HomeLink" you want to program.





2. Place your hand- held garage transmitter 25 to 75 mm (1 to 3 in.) away from the surface of the HomeLink".

Keep the indicator light on the HomeLink" in view while programming.

Toyota Avalon Garage Doors

3. Simultaneously press and hold the hand- held garage transmitter button along with the selected HomeLink- button.

Do not release the buttons until step 4 has been completed.

4. When the indicator light on the HomeLink- changes from a slow to a rapid flash after 20 seconds, you can release both buttons.

5. Test the operation of the HomeLink- by pressing the newly programmed button. If programming a garage door opener, check to see if the garage door opens and closes.

If the garage door does not operate, identify if your garage transmitter is of the "Rolling Code" type. Press and hold the programmed HomeLink- button. The garage door has the rolling code feature if the indicator light (on the HomeLink-) flashes rapidly and then remains lit after 2 seconds. If your garage transmitter is the "Rolling Code" type, proceed to the heading "Programming a rolling code system".

6. Repeat steps 2 through 5 for each remaining HomeLink- button to program another device.

Programming a rolling code system If your device is "Rolling Code" equipped, it is necessary to follow steps 1 through 4 under the heading "Programming the HomeLink-" before proceeding with the steps listed below.

1. Locate the "training" button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener. Refer to the owner's guide supplied by the garage door opener manufacturer for the location of this "training" button.

2. Press the "training" button on the ceiling mounted garage door opener motor.

Following this step, you have 30 seconds in which to initiate step 3 below.

3. Press and release the vehicle's programmed HomeLink- button twice. The garage door may open. If the door does open, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door.

The ceiling mounted garage door opener motor should now recognize the HomeLink- unit and be able activate the garage door up/down.

4. Repeat steps 1 through 3 for each remaining HomeLink- button to program another rolling code system.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


  • ville
    Does toyota avalon all have garage door opener?
    3 years ago
  • raine
    How to program garage door opener in 2000 toyota avalon?
    3 years ago
  • rose
    How to program 2013 alvolon garage door opener?
    3 years ago
    Do Toyota homelink units need batteries?
    2 years ago
  • theo
    How to program garage door opener in 2002 toyota avalon?
    2 years ago

Post a comment