Inspection Procedure

NOTICE:

The vehicle is equipped with an SRS (Supplemental Restraint System), such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the Supplemental Restraint System (See page RS-1).

INSPECT RADIO RECEIVER

Wire Harness View (12 Speaker):

Wire Harness View (9 Speaker, 1 CD Type):

2CH-1CH GND

Wire Harness View (9 Speaker, 6 CD Type):

1CH

(a) Disconnect the radio receiver E15 connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance

Tester connection

Condition

Specified condition

1CH-GND

No switch is pushed

Approx. 100 kQ

1CH-GND

SEEK+ switch: push

Approx. 0 Q

1CH - GND

SEEK- switch: push

Approx. 0.3 kQ

1CH-GND

VOL+ switch: push

Approx. 1 kQ

1CH - GND

VOL- switch: push

Approx. 3.2 kQ

2CH - GND

No switch is pushed

Approx. 100 kQ

2CH - GND

MODE switch: push

Approx. 0 Q

Go to step 2

Go to step 2

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

INSPECT STEERING PAD SWITCH ASSEMBLY

(a) Disconnect the steering pad switch connector.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment