Read Data List

(a) While the intelligent tester is connected to the DLC3 with the ignition switch turned on (IG), the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list. CC (ECM):_

Item

Measurement Item / Display (Range)

Normal Condition

Diagnostic Note

VEHICLE SPD

Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)

Actual vehicle speed

-

MEMORY SPD

Cruise control memorized speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)

Actual stored vehicle speed

-

RQSTTORQUE

Cruise request torque / min.: -1,024 N*m, max.: 1016 N*m

Actual torque

-

CRUISE CONTROL

Cruise control system active condition / ON or OFF

ON: Cruise control activated OFF: Cruise control inactivated

-

MAIN SW (MAIN)

Main switch signal (Main CPU) / ON or OFF

ON: Main switch ON (Pushed on) OFF: Main switch OFF (Pushed off)

"3"

CCS READY M

Cruise control system standby condition (Main CPU) / ON or OFF

ON ^^ OFF: Change ON/OFF each time Main SW is pushed in.

"1"

CCS INDICATOR M

Cruise indicator signal (Main CPU) / ON or OFF

ON: "CCS READY" ON OFF: "CCS READY" OFF

"2"

CANCEL SW

CANCEL switch signal / ON or OFF

ON: CANCEL switch ON OFF: CANCEL switch OFF

-

SET/- SW

SET/- SW signal / ON or OFF

ON: SET/- SW ON OFF: SET/- SW OFF

-

RES/+ SW

RES/+ SW signal / ON or OFF

ON: RES/+ SW ON OFF: RES/+ SW OFF

-

STP LIGHT SW M

Stop light SW signal (Main CPU) / ON or OFF

ON: Brake pedal depressed OFF: Brake pedal released

-

SHIFT D POS

PNP SW signal (D position) / ON or OFF

ON: Shift position D OFF: Any shift position except D

"3" is OK but "1" is NG ^ECM failure

"1" is OK but "2" is NG ^ DTC output or ECM

failure

"3" is OK but cruise indicator not turn on ^ CRUISE MAIN indicator or wire harness or ECM failure 2. ACTIVE TEST HINT:

Performing the ACTIVE TEST using the intelligent tester allows components such as the relay, VSV, and actuator to operate with out parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten labor time. It is possible to display the DATA LIST during the ACTIVE TEST.

(a) Connect the intelligent tester to the DLC3.

(b) turn the ignition switch on (IG).

(c) According to the display on the tester, perform the "ACTIVE TEST". HINT:

The ignition switch must be turned on (IG) to proceed with the ACTIVE TEST using the intelligent tester.

COMBINATION METER ASSEMBLY:

Item

Vehicle Condition / Test Details

Diagnostic Note

CRUISE INDIC

"CRUISE" indicator is ON / OFF

-

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment