Reassembly

1. INSTALL UNDERDRIVE PLANETARY RING GEAR

(a) Install a new snap ring to the outer race of the radial ball bearing rear. HINT:

When replacing the bearing, also replace the counter driven gear with a new one.

(b) Using a piston ring compressor, squeeze the snap ring.

(c) Using SST and a press, press in the outer race of the radial ball bearing rear. SST 09950-60020 (09951-00890), 09950-70010

(09951-07100) NOTICE:

Be sure not to damage the snap ring during outer race installation.

(d) Install the underdrive planetary ring gear to the counter driven gear.

(e) Using a snap ring pliers, install the snap ring.

2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY

(a) Using SST and a press, press the radial ball bearing rear in the underdrive planetary gear. SST 09502-12010, 09950-60010 (09951-00260),

09950-70010 (09951-07100) NOTICE:

Press the bearing until it becomes flat at the bottom.

(b) Install the counter driven gear with planetary ring gear to the underdrive planetary gear.

(c) Using SST and a press, press in the radial ball bearing front.

SST 09502-12010, 09950-60010 (09951-00260),

09950-70010 (09951-07100) NOTICE:

Press the counter driven gear while rotating it.

(d) Using SST and a press, press in the parking lock gear.

SST 09502-12010, 09950-60010 (09951-00260),

09950-70010 (09951-07100) NOTICE:

Press the counter driven gear while rotating it.

3. INSTALL DIFFERENTIAL DRIVE PINION

(a) Using SST and a press, press the differential drive pinion.

SST 09726-40010, 09950-60010 (09951-00260),

09950-70010 (09951-07100) NOTICE:

Press the counter driven gear while rotating it.

4. INSTALL CYLINDRICAL ROLLER BEARING RACE INNER

(a) Using SST and a press, press the cylindrical roller bearing race inner.

SST 09506-35010, 09950-60010 (09951-00260),

09950-70010 (09951-07100) NOTICE:

Press the counter driven gear while rotating it.

Underdrive

Underdrive

5. INSTALL FRONT PLANETARY GEAR NUT

(a) Place the underdrive planetary gear in a soft jaw vise.

NOTICE:

Be careful not to damage the differential drive pinion.

(b) Using a socket wrench, install a new lock nut. Torque: 280 N*m (2,885 kgf*cm, 207 ft.*lbf)

HINT:

Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).

(c) Using a pin punch and hammer, stake the lock nut. CAUTION:

Be sure that there are no cracks on the nut.

6. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD

HINT:

(See page AX-261)

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment