Removal

1. TABLE OF BOLT, SCREW AND NUT (See page IP-8)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE STEERING WHEEL COVER LOWER NO. 2 (See page RS-304)

4. REMOVE STEERING WHEEL COVER LOWER NO. 3 (See page RS-304)

REMOVE STEERING PAD (See page RS-304)

0= Claw

E127758E01

REMOVE STEERING WHEEL ASSEMBLY (See page SR-36)

REMOVE STEERING COLUMN COVER (See page SR-36)

REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE (See page SR-36)

9. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 1 (See page IP-9)

10. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2 (See page IP-9)

11. REMOVE INSTRUMENT PANEL FINISH PLATE (See page IP-9)

12. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (See page IP-9)

13. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER (See page AC-180)

14. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See page IP-10)

15. REMOVE ACCESSORY METER ASSEMBLY (See page IP-10)

16. REMOVE MULTI DISPLAY

(a) Disengage the 9 claws and remove the back cover.

(b) Remove the 4 screws and multi display.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment