Removal

HINT:

• Installation is in the reverse order of removal.

• COMPONENTS for instrument panel safety pad subassembly: See page IP-2.

1. DISCONNECT BATTERY NEGATIVE TERMINAL

(a) Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH (See page WW-38)

3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH (See page WW-38)

4. REMOVE COWL TOP VENTILATOR LOUVER RH (See page WW-38)

5. REMOVE WINDSHIELD WIPER MOTOR AND LINK (See page WW-38)

6. REMOVE COWL TOP OUTSIDE PANEL FRONT

(a) Remove the 4 bolts, 2 nuts and cowl top outside panel front.

7. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See page AC-138)

8. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

(a) Remove the bolt, and slide the hook connector.

(b) Disconnect the suction hose sub-assembly.

(c) Remove the O-ring from the suction hose subassembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.

9. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY

(a) Disconnect the air conditioner tube & accessory.

(b) Remove the O-ring from the air conditioner tube & accessory.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.

10. DISCONNECT HEATER WATER OUTLET HOSE A(FROM HEATER UNIT)

(a) Slide the clip and disconnect the heater water outlet hose A. NOTICE:

• Do not apply excessive force to the heater water outlet hose A.

• Prepare a drain pan or cloth in case the cooling water leaks.

11. DISCONNECT HEATER WATER INLET HOSE A

(a) Slide the clip and disconnect the heater water inlet hose A.

NOTICE:

• Do not apply excessive force to the heater water inlet hose A.

• Prepare a drain pan or cloth in case the cooling water leaks.

12. REMOVE INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY

IP-8 HINT:

Refer to the removal procedures for the instrument panel safety pad sub-assembly w/ front passenger airbag assembly.

13. REMOVE HEATER TO REGISTER DUCT NO.2

(a) Remove the 3 clips and heater to register duct No.2.

14. REMOVE HEATER TO REGISTER DUCT ASSEMBLY NO.6

(a) Disengage the 4 claws and then remove the heater to register duct No.6.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment