Service Mode Vsc and TRAC prohibited mode

HINT:

VSC and TRAC control can be prohibited by switching to service mode.

(a) Procedures for service mode.

HINT:

• Perform step (See procedure "A") to (See procedure "E") within 30 seconds.

• Perform step (See procedure "C") and (See procedure "D") within 15 seconds each.

• Make sure that the shift lever is in the P position.

(1) Turn the ignition switch on (IG).

(2) Apply the parking brake (Procedure "A").

(3) Depress and release the brake pedal twice (Procedure "B").

(4) While holding the brake pedal down, release and apply the parking brake twice (Procedure "C").

(5) With the parking brake applied, depress and release the brake pedal twice (Procedure "D").

(6) Check that the VSC warning light and SLIP indicator light come on (Procedure "E").

HINT:

• If the VSC warning light and SLIP indicator light do not come on, repeat the procedures.

• Turning the ignition switch off ends service mode.

HOW TO PROCEED WITH TROUBLESHOOTING

The intelligent tester can be used at steps 3, 4, 6, 7, 11, 14, and 17.

VEHICLE BROUGHT TO WORKSHOP

ljnextj

CUSTOMER PROBLEM ANALYSIS

LjnextJ

CHECK DTC AND FREEZE FRAME DATA

ljnextj

CLEAR DTC AND FREEZE FRAME DATA

ljnextj

PROBLEM SYMPTOM CONFIRMATION

ljnextj

CHECK CAN COMMUNICATION SYSTEM

(a) Check for output DTCs. HINT:

The ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

CAN COMMUNICATION SYSTEM DTC IS OUTPUT: PROCEED TO CAN COMMUNICATION SYSTEM

NO CAN COMMUNICATION SYSTEM DTC IS OUTPUT: GO TO STEP 7

CHECK MULTIPLEX COMMUNICATION SYSTEM

(a) Check for output DTCs.

HINT:

The skid control ECU sends the signals of each warning light to the gateway ECU via CAN communication, and the gateway ECU sends the signals to the combination meter via multiplex communication system (BEAN).

MULTIPLEX COMMUNICATION SYSTEM DTC IS OUTPUT: PROCEED TO MULTIPLEX COMMUNICATION SYSTEM

NO MULTIPLEX COMMUNICATION SYSTEM DTC IS OUTPUT: GO TO STEP 8

DTC CHECK AND CLEAR

ljnextj

PROBLEM SYMPTOM SIMULATION

SYMPTOM DOES NOT OCCUR: GO TO STEP 10

SYMPTOM OCCURS: GO TO STEP 11

10

SYMPTOM SIMULATION

ljnextj

11

DTC CHECK (OTHER THAN CAN AND MULTIPLEX COMMUNICATION SYSTEM DTC)

>

NORMAL SYSTEM CODE: GO TO STEP 12

>

TROUBLE CODE: GO TO STEP 13

12

PROBLEM SYMPTOMS TABLE

ljnextj

GO TO STEP 14

13

CIRCUIT INSPECTION

l^nextj

IDENTIFICATION OF PROBLEM

l^nextj

REPAIR OR REPLACE

l^nextj

CONFIRMATION TEST

ljnextj

Intelligent Tester

Intelligent Tester

CHECK FOR INTERMITTENT PROBLEMS

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment