Disconnect Transmission Wire

(a) Disconnect the 7 shift solenoid valve connectors.

(b) Remove the bolt and lock plate, and disconnect the ATF temperature sensor.

Toyota Camry Transmission Solenoid

5. REMOVE VALVE BODY OIL STRAINER ASSY

(a) Remove the 3 bolts and oil strainer. NOTICE:

Be careful that some fluid will come out of the oil strainer.

(b) Remove the O-ring from the oil strainer.

6. REMOVE TRANSMISSION VALVE BODY ASSY

(a) Support the valve body assy and remove the 17 bolts and the valve body assy. NOTICE:

Be careful not to drop the check ball, spring and accumulator piston.

(b) Remove the check ball body and spring.

Shift Solenoid Valve Toyota Rav

(c) Remove the 5 bolts and 7 shift solenoid valves.

Porterbuilt Bolt Body Drop

7. INSTALL TRANSMISSION VALVE BODY ASSY

(a) Install the spring and check ball body.

Shift Solenoid Toyota Rav4 Location

(b) Install the 7 shift solenoid valves with the 5 bolts. Torque:

Bolts A, B: 11 Nm (110 kgfcm, 8 ft. Ibf) Bolts C, D: 6.6 N m (67 kgf cm, 58 in. Ibf) Bolt length:

Bolt A: 16 mm (0.63 in.) Bolt B: 57 mm (2.2 in.) Bolt C: 23 mm (0.9 in.) Bolt D: 12 mm (0.47 in.)

Align the groove of the manual valve with the pin of the lever.

Install the 17 bolts.

Push the valve body against the accumulator piston spring and the check ball body to install it. First, temporarily tighten the bolts marked by • in the illustration because they are positioning bolts. Bolt length:

Bolt A: 25 mm (0.984 in.) Bolt B: 57 mm (2.244 in.) Bolt C: 41 mm (1.614 in.)

INSTALL VALVE BODY OIL STRAINER ASSY

Coat a new O-ring with ATF. Install the O-ring to the oil strainer.

2002 Camry Wiper Motor Repair

(c) Install the oil strainer with the 3 bolts. Torque: 11 N m (110 kgfcm, 8 ft Ibf)

9. INSTALL TRANSMISSION WIRE

(b) Install the ATF temperature sensor with the lock plate and bolt.

(c) Connect the 7 shift solenoid valve connectors.

D30865

10. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSY

(a) Install the 2 magnets in the oil pan.

(b) Apply seal packing or equivalent to the 18 bolts. Seal packing:

THREE BOND 2430 or equivalent

D30865

(c) Using a new gasket, install the oil pan with the 18 bolts to the transaxle case.

Since the bolts should be seal bolts, apply seal packing to the bolts and tighten them within 10 minutes of application.

11. ADD AUTOMATIC TRANSAXLE FLUID Fluid type: ATF type T-IV

12. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2)

13. INSTALL ENGINE UNDER COVER RH

14. RESET MEMORY (SEE PAGE 05-1251)

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment