After replacing the ECM or adjusting intake valve timing confirm that the DTC output does not recur

Total OBD & ECU Auto Diagnostics

TOAD Auto Diagnostics

Get Instant Access

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch to the ON position.

(e) Switch the ECM from normal mode to check mode using the tester (See page ES-41).

(f) Start the engine and warm it up.

(g) Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.

(h) Confirm that no DTC is set using the tester. OK:

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment