If the results are not displayed normally select the display items from the Data List before performing the Active Test Select the following menu items Diagnosis Enhanced Obd Ii Data List User Data Eng Speed and Eng Speed Eng Speed Eng Speed Press the YES

ENG SPEED #1

243rpm

ENG SPEED #2

244rpm

ENG SPEED #3

245rpm

ENG SPEED #4

244rpm

ENG SPEED ALL

244rpm

COMPRESS CHECKS►►►►►►►►►►►ON

A130535

6. While the engine is not running, press the RIGHT or LEFT button to change the COMPRESS CHECK to ON.

HINT:

After performing the above procedure, the ACTIVE TEST's COMPRESS CHECK will start. Fuel injection for all cylinders is prohibited, and each cylinder's engine rpm measurement will enter standby mode.

7. Fully open the throttle.

8. Crank the engine for about 10 seconds.

9. Monitor the engine speed (ENG SPEED #1 to #4) displayed on the tester.

HINT:

At first, the tester's display will show each cylinder's engine rpm measurement to be extremely high. After approximately 10 seconds of engine cranking, each cylinder's engine rpm measurement will change to the actual engine rpm. NOTICE:

• After the ACTIVE TEST's COMPRESS CHECK is turned ON, it will automatically turn off after 255 seconds.

• When the COMPRESS CHECK test is OFF and the engine is cranked, the engine will start.

• If the COMPRESS CHECK test needs to be performed after it is turned ON and performed once, press EXIT to return to the ACTIVE TEST menu screen. Then perform the COMPRESS CHECK test again.

• Use a fully-charged battery. 3. SYSTEM CHECK

HINT:

Performing a SYSTEM CHECK enables the system, which consists of multiple actuators, to be operated without removing any parts. In addition, it can show whether or not any DTCs are set, and can detect potential malfunctions in the system. The SYSTEM CHECK can be performed with the intelligent tester.

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch to the ON position.

(d) Select the following menu items: DIAGNOSIS / ENHANCED OBD II / SYSTEM CHECK.

(e) Perform the SYSTEM CHECK by referring to the table below.

ECM:

Intelligent Tester Display

Test Detail

Recommended Fuel Temperature

Diagnostic Note

EVAP SYS CHECK (AUTO OPERATION)

Perform 5 steps in order to operate EVAP key-off monitor automatically

35°C (95°F) or less

• If no DTCs in PENDING CODE after performing this test, system functioning normally

• Refer to EVAP system

EVAP SYS CHECK (MANUAL OPERATION)

Perform 5 steps in order to operate EVAP key-off monitor manually

35°C (95°F) or less

• Used to detect malfunctioning parts

• Refer to EVAP system

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment