Install Fuel Tank Assembly

(a) Install the 4 clip nuts (Except SE Grade).

^___

c —"

y

/ // Fuel Tube Connector

/ // Fuel Tube Connector

-__ _

—_ / nSfSSi \

\ )

jr fr^i- ^ / L 77

I 1

P ^---^

A081598E03

(c) Install the 2 fuel tank bands with the 2 pins.

(d) Set the fuel tank assembly onto the transmission jack.

(e) Raise the transmission jack so that the fuel tank vent hose can be connected. (*1)

NOTICE:

Slowly raise the jack to prevent the fuel tank assembly from dropping.

(f) Connect the fuel tank inlet pipe with the fuel filter pipe clamp. (*2)

(g) Tighten the 2 set bolts of the fuel tank bands. (*3) Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)

(1) Push the fuel tube connector into the pipe until the fuel tube connector makes a "click" sound. NOTICE:

• Before connecting the tube, make sure that it is not damaged. Make sure that there is no dirt present on the connecting surfaces.

• After connecting, check if the fuel tube connector and the pipe are securely connected by pulling on them.

(i) Connect the fuel pump tube.

(1) Push the fuel connector into the pipe and push up the retainer so that the claws engage. NOTICE:

• Before connecting the tube, make sure that it is not damaged. Make sure that there is no dirt present on the connecting surfaces.

• After connecting, check if the fuel tube connector and the pipe are securely connected by pulling on them.

6. INSTALL FUEL TANK PROTECTOR LOWER CENTER

(a) Install the 4 bolts and fuel tank protector (Except SE Grade).

(b) Install the fuel tank protector with the 4 bolts and 2 clips (for SE Grade). Torque: Bolt

7. INSTALL REAR STABILIZER BAR NO. 1 BRACKET

(a) Install the 2 rear stabilizer bar No. 1 brackets with the 4 bolts.

8. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 3 parking brake cable assembly with the bolt and nut.

Torque: Bolt

9. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 2 parking brake cable assembly with the bolt and nut. Torque: Bolt

10. INSTALL CENTER EXHAUST PIPE ASSEMBLY (See page EX-4)

11. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE (See page FU-32)

12. INSTALL FUEL TANK VENT TUBE SET PLATE (See page FU-32)

13. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY (See page FU-33)

14. ADD FUEL

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. CHECK FOR FUEL LEAKS (See page FU-8)

17. CHECK FOR EXHAUST GAS LEAKS

18. INSTALL REAR FLOOR SERVICE HOLE COVER

19. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) (See page SE-84)

20. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) (See page SE-58)

21. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) (See page SE-73)

IGNITION SYSTEM PARTS LOCATION

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment