Install Generator Clutch Pulley

(a) Temporarily install the clutch pulley onto the rotor shaft.

Rotor Shaft SST (A)

Rotor Shaft SST (A)

(f) Tighten the pulley by turning SST (B) in the direction shown in the illustration.

The torque shown above should be used for tightening without using the SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (See page IN-6).

(g) Remove the generator assembly from the SST.

(h) Check that the clutch pulley rotates smoothly.

(i) Install a new clutch pulley cap to the clutch pulley.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment