Installation

1. INSTALL WATER PUMP ASSEMBLY

(a) Remove any old seal packing material from the contact surface.

(b) Apply a continuous line of seal packing as shown in the illustration.

Seal packing: Toyota Genuine Seal Packing Black, Three Bond 1207B or Equivalent Standard seal diameter:

• Remove any oil from the contact surface.

• The parts must be set within 3 minutes after applying seal packing. Otherwise, the material must be removed and reapplied.

(c) Install the water pump and clamp bracket with the 4 bolts and 2 nuts.

(d) Install the wire of the crankshaft position sensor onto the clamp bracket.

(e) Install the clamp of the crankshaft position sensor onto the water pump.

2. INSTALL WATER PUMP PULLEY

(a) Using SST, install the water pump pulley with the 4 bolts.

SST 09960-10010 (09962-01000, 09963-00700) Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)

3. INSTALL GENERATOR ASSEMBLY (See page CH-19)

4. INSTALL V-RIBBED BELT (See page EM-6)

5. INSTALL NO. 2 ENGINE MOUNTING BRACKET RH (See page EM-118)

6. INSTALL ENGINE MOVING CONTROL ROD SUBASSEMBLY (See page EM-119)

7. INSTALL NO. 2 ENGINE MOUNTING STAY RH (See page EM-119)

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See page EM-120)

9. ADD ENGINE COOLANT (See page CO-5)

10. CHECK FOR ENGINE COOLANT LEAKS (See page CO-1)

11. INSTALL ENGINE UNDER COVER LH

12. INSTALL ENGINE UNDER COVER RH

13. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

14. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment