Installation

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)

(c) Connect the crankshaft position sensor connector.

2. INSTALL GENERATOR ASSEMBLY (See page CH-19)

3. INSTALL V-RIBBED BELT (See page EM-7)

4. INSTALL FRONT FENDER APRON SEAL RH

5. INSTALL FRONT WHEEL RH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment