Installation

1. INSTALL V-RIBBED BELT

(a) Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the V-ribbed belt. SST 09216-42010 NOTICE:

• Be sure to connect SST and the tools so that they are in line during use.

• When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.

• After the tensioner is fully retracted, do not apply force any more than necessary.

(b) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Check to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

2. INSTALL FRONT FENDER APRON SEAL RH

3. INSTALL ENGINE UNDER COVER RH

4. INSTALL FRONT WHEEL RH

VALVE CLEARANCE

Timing Mark

Timing Mark

Timing Mark

Groove

Groove

A098345E09

A098345E09

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment