Installation

1. INSTALL INTAKE AIR CONTROL VALVE

(a) Install the intake air control valve.

2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY

HINT:

(See page ES-511)

LUBRICATION SYSTEM

ON-VEHICLE INSPECTION

Oil Pressure Gauge

CHECK ENGINE OIL LEVEL

(a) Warm up the engine, stop the engine and wait for 5 minutes.

(b) Check that the engine oil level is between the L and F marks of the oil dipstick.

If low, check for leakage and add oil up to the F

mark.

NOTICE:

Do not add engine oil above the F mark.

CHECK ENGINE OIL QUALITY

(a) Check the oil for deterioration, water intrusion, discoloration or thinning. If the quality is visibly poor, replace the oil. Oil grade:

Use ILSAC multigrade engine oil. SAE 5W-20 and SAE 0W-20 engine oil may be used. However, SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather.

CHECK OIL PRESSURE

(a) Disconnect the oil pressure switch connector.

(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.

(c) Install the oil pressure gauge.

(e) Measure the oil pressure. Standard oil pressure

Condition

Specified Condition

Idle

29 kPa (0.3 kgf/cm2, 4.3 psi) or more

3,000 rpm

170 to 300 kPa (1.7 to 3.1 kgf/cm2, 24 to 44 psi)

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment