Installation

1. INSTALL OIL PUMP ASSEMBLY

(a) Install a new gasket and the oil pump with the 3 bolts.

2. INSTALL NO. 2 CHAIN SUB-ASSEMBLY (See page EM-27)

3. INSTALL CRANKSHAFT TIMING SPROCKET (See page EM-28)

4. INSTALL NO. 1 CHAIN VIBRATION DAMPER (See page EM-28)

5. INSTALL CHAIN SUB-ASSEMBLY (See page EM-28)

6. INSTALL CHAIN TENSIONER SLIPPER (See page EM-29)

7. INSTALL TIMING CHAIN GUIDE (See page EM-30)

8. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE (See page EM-30)

9. INSTALL TIMING CHAIN CASE OIL SEAL

(a) Using SST, tap in a new oil seal until its surface is flush with the timing chain cover edge.

SST 09223-22010

(b) Apply a light coat of MP grease to the lip of the oil seal.

NOTICE:

Keep the gap between the timing chain cover edge and the oil seal free of foreign matter.

10. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY

(a) Remove any old packing (FIPG) material and be careful not to drop any oil on the contact surfaces of the timing chain cover, cylinder head and cylinder block.

(b) Apply seal packing (diameter: 4.0 to 4.5 mm (0.157 to 0.177 in.)) as shown in the illustration.

Seal packing: Toyota Genuine Seal Packing Black, Three Bond 1207B or Equivalent

(c) Apply seal packing in a continuous bead as shown in the illustration.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment