Installation

1. INSTALL GENERATOR ASSEMBLY

(a) Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.

(b) Install the generator assembly with the 2 bolts. Torque: Bolt A

(c) Install the generator wire to terminal B with the nut. Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)

(d) Install the clamp bracket with the bolt. Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)

(e) Attach the clamp and connect the generator connector to the generator.

INSTALL V-RIBBED BELT (See page EM-6)

INSTALL FRONT FENDER APRON SEAL RH

INSTALL ENGINE UNDER COVER RH

INSTALL FRONT WHEEL RH (See page EM-7)

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See page EM-120)

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment