Mm in

o Normal X Twisted o Normal X Twisted

(c) After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it. HINT:

When cleaning the lock plate groove, lightly rub it with sand paper without scratching it.

(d) Install the tank without damaging the O-ring.

(e) Tap the lock plate with a soft-faced hammer so that there is no gap between the lock plate and the tank.

(f) Lightly press SST against the lock plate in the order shown in the illustration. After repeating this a few times, fully caulk the lock plate by gripping the handle until stopped by the stopper plate. HINT:

• Do not tap the areas protruding around the pipes, brackets or tank ribs.

• The dotted circles shown in the illustration and parts of the oil cooler near the dotted circles cannot be tapped with the SST. Use pliers or similar objects and be careful not to damage the core plates.

(g) Check the lock plate height (H) after completing caulking. Plate height (H): 7.40 to 7.80 mm (0.2913 to 0.3071 in.)

If not within the specified height range, adjust the stopper bolt of the handle and caulk again.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment