Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

4. REMOVE ENGINE UNDER COVER RH

5. REMOVE ENGINE UNDER COVER LH

6. DRAIN ENGINE COOLANT (See page CO-5)

7. REMOVE FRONT FENDER APRON SEAL RH

8. REMOVE NO. 2 ENGINE MOUNTING STAY RH (See page EM-95)

9. REMOVE ENGINE MOVING CONTROL ROD SUBASSEMBLY (See page EM-95)

10. REMOVE NO. 2 ENGINE MOUNTING BRACKET RH (See page EM-96)

11. REMOVE V-RIBBED BELT (See page EM-6)

12. REMOVE GENERATOR ASSEMBLY (See page CH-11)

13. REMOVE WATER PUMP PULLEY

(a) Using SST, remove the 4 bolts and water pump pulley.

SST 09960-10010 (09962-01000, 09963-00700)

14. REMOVE WATER PUMP ASSEMBLY

(a) Remove the clamp of the crankshaft position sensor from the water pump.

(b) Disconnect the wire of the crankshaft position sensor from the clamp bracket.

(c) Remove the 4 bolts, 2 nuts and clamp bracket.

(d) Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump. HINT:

Tape the screwdriver tip before use. NOTICE:

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment