Wipe off extra grease on the crankshaft

18. INSTALL NO. 1 TAPER SCREW PLUG (w/o Oil Cooler)

(a) Apply adhesive to 2 or 3 threads of the plug, and install the plug.

Toyota Genuine Adhesive 1324, Three Bond 1324 or Equivalent

19. INSTALL OIL CONTROL VALVE FILTER

(a) Check that no foreign matter is on the mesh part of the filter.

(b) Using an 8 mm socket hexagon wrench, install a new gasket and the oil control valve filter with the screw plug.

Do not touch the mesh when installing the oil control valve filter.

20. INSTALL CYLINDER BLOCK WATER DRAIN COCK SUB-ASSEMBLY (w/o Oil Cooler)

(a) Apply adhesive around the drain cock.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent

(b) Install the water drain cock within the range shown in the illustration.

Do not rotate the drain cocks more than 1 revolution (360°) after tightening the drain cocks to the specified torque.

(c) Install the water drain cock plugs to the water drain cocks.

-Virn-1 1-r

A090053E02

r

21. INSTALL CYLINDER BLOCK WATER JACKET SPACER

(a) Install the water jacket spacer as shown in the illustration. HINT:

Be sure to face the slope to the front of the engine.

22. INSTALL CYLINDER HEAD GASKET (See page EM-70)

23. INSTALL CYLINDER HEAD SUB-ASSEMBLY (See page EM-70)

24. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

(a) Apply a light coat of engine oil to a new O-ring, then install it onto the camshaft timing oil control valve.

(b) Install the camshaft timing oil control valve with the bolt.

25. INSTALL CAMSHAFT TIMING GEAR ASSEMBLY (See page EM-42)

26. INSTALL CAMSHAFT TIMING SPROCKET

(a) Clamp the camshaft in a vise.

(b) Tighten the flange bolt with the camshaft timing sprocket fixed.

A128191

27. INSTALL NO. 1 CAMSHAFT BEARING

(a) Install the No. 1 camshaft bearing.

28. INSTALL NO. 2 CAMSHAFT BEARING (See page EM-71)

29. INSTALL CAMSHAFT

(a) Apply a light coat of engine oil to the journal portion of the camshaft.

(b) Examine the front marks and numbers, and check that the order is as shown in the illustration. Then install the bearing caps into the cylinder head.

(c) Apply a light coat of engine oil to the threads and under the heads of the bearing cap bolts.

(d) Using several steps, uniformly tighten the 10 bearing cap bolts in the sequence shown in the illustration.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment