Inspection Procedure

CHECK RADIO AND NAVIGATION ASSEMBLY

(a) Check the radio's automatic station search function. (1) Check the radio's automatic station search function by activating it. OK:

The radio's automatic station search function works properly.

QNT}

REPLACE RADIO AND NAVIGATION ASSEMBLY

INSPECT RADIO AND NAVIGATION ASSEMBLY

Wire Harness View:

Wire Harness View:

(a) Disconnect the radio and navigation assembly connector F9.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage

Tester connection

Condition

Specified condition

ANT - Body ground

Ignition SW on (IG) Radio SW ON

10 to 14 V

REPLACE RADIO AND NAVIGATION ASSEMBLY

CHECK OPTIONAL COMPONENTS

(a) Check optional components (sun-shade film, telephone antenna, etc.).

(1) Check if any optional components, such as sunshade film or telephone antenna that may decrease reception capacity, are installed. OK:

Optional components are installed. NOTICE:

Do not remove any optional components installed by the customer without his or her consent.

REMOVE AND RECHECK OPTIONAL COMPONENTS (SEE NOTICE ABOVE)

CHECK RADIO AND NAVIGATION ASSEMBLY

(a) Preparation for check

(1) Remove the antenna plug from the radio and navigation assembly.

(b) Check for noise

(1) Turn the ignition switch on (ACC) with the radio and navigation assembly connector connected.

(2) Turn the radio on and put into AM mode.

(3) Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.

OK: Noise occurs.

REPLACE RADIO AND NAVIGATION ASSEMBLY

CHECK GLASS ANTENNA

Tester Probe

Tester Probe

Tin Foil

Antenna Wire

Tin Foil

Antenna Wire

(a) Check for continuity of the antenna. HINT:

Check for continuity at the center of each antenna wire as shown in the illustration.

NOTICE:

When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wrap a piece of tin foil around the tip of the negative probe and press the foil against the wire with your finger, as shown in the illustration. OK:

There is continuity in the antenna.

REPAIR GLASS ANTENNA

REPLACE ANTENNA AMPLIFIER

(a) Replace the antenna amplifier and check that it operates normally. OK:

The antenna amplifier operates normally.

REPLACE RADIO AND NAVIGATION ASSEMBLY

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment