Inspection Procedure

CHECK GPS MARK

. "<0ff Map View Route Mark

. "<0ff Map View Route Mark

(a) Check that the GPS mark is displayed. OK:

GPS mark is displayed.

GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE

E125110E01

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

Vehicle Sensors

Nävi Menu |

Vehicle Signal -REV

Sensor Signal-r Gyro Voltage : '-Relative bearing :

:Ji82SJ3ijll§?s

: 359.9 oegrees

I Reset I

(a) Enter the "Navigation Check" mode (Vehicle Sensors) (See page NS-27).

(b) While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

The readings are almost equal.

GO TO "SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

Vehicle Sensors

1 Navl Menu |

Vehicle Signal -REV

■ SPD -r Pulse Count

'VüäSST'ulSis

LSpeed

: 75 mph

180 km/h

Sensor Signal -r Gyro Voltage L Relative bearing

:2.500 V : 359.9 degrees

Reset

(a) Check that the display changes between ON and OFF according to the shift lever operation. OK

Shift Lever Position

Display

Except Reverse

OFF

Reverse

ON

GO TO "REVERSE SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE

HINT:

The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment