Ip

for TMMK Made:

NO. 3 INSTRUMENT PANEL STAY

NO. 3 INSTRUMENT PANEL STAY

NO. 1 INSTRUMENT PANEL PIN

<O> GLOVE BOX LIGHT ASSEMBLY

with Plasmacluster:

PLASMACLUSTER

PLASMACLUSTER

DEFROSTER NOZZLE ASSEMBLY

DEFROSTER NOZZLE ASSEMBLY

SIDE NO. 2 DEFROSTER -NOZZLE DUCT

SIDE NO. 1 DEFROSTER NOZZLE DUCT

NO. 2 HEATER TO REGISTER DUCT

<O>

4 NO. 3 HEATER TO REGISTER DUCT <O>

NO. 1 HEATER TO REGISTER DUCT

4 NO. 3 HEATER TO REGISTER DUCT <O>

FRONT PASSENGER AIRBAG ASSEMBLY

with Navigation system:

NAVIGATION ANTENNA ASSEMBLY

NO. 2 ANTENNA CORD SUB-ASSEMBLY

NO. 2 ANTENNA CORD SUB-ASSEMBLY

B137287E01

REMOVAL

1. PRECAUTION

2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See page RS-1).

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER (See page RS-349)

5. REMOVE LOWER NO. 2 STEERING WHEEL COVER (See page RS-349)

6. REMOVE STEERING PAD (See page RS-350)

7. REMOVE STEERING WHEEL ASSEMBLY (See page SR-38)

8. REMOVE FRONT DOOR SCUFF PLATE LH (See page IR-24)

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (See page IR-25)

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made)

(a) Remove the bolt <A> and the screw <B>.

(b) Disconnect the hood lock control cable assembly.

(c) Disengage the claw and the 9 clips.

(d) Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.

11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made)

(a) Remove the bolt <N> and the screw <O> or <P>.

(b) Disconnect the hood lock control cable assembly.

(c) Disengage the claw and the 9 clips.

(d) Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.

12. REMOVE STEERING COLUMN COVER (for TMC Made)

(b) Disengage the 2 claws and remove the lower steering column cover.

(c) Disengage the claw and remove the upper steering column cover.

13. REMOVE STEERING COLUMN COVER (for TMMK Made)

(b) Disengage the 2 claws and remove the lower steering column cover.

(c) Disengage the claw and remove the upper steering column cover.

14. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY (See page SR-39)

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment