Body Panel Undercoating Areas

Apply PASTAR UWE or PASTAR UC to the chassis, floor underside, sheet metal fitting weld points of the body, and inside of the wheel house to prevent rust and noise, as well protect the body from flying rocks.

HINT:

1) Work must be performed while wearing the appropriate protective gear and in a well-ventilated area.

2) Apply degreasing agent to a clean cloth and clean any dirt and oil from the application areas. Cover the surrounding areas of the application areas with masking paper to avoid coating unnecessary areas. Do not coat high temperature areas, such as the tailpipe, or moving parts, such as the driveshaft. Do not leave any gaps between the panel joints. Apply sealer to the panel joints in advance.

Parts coated using the PASTAR UWE should be left until dry to the touch in a 25°C environment for 60 to 75 minutes. Parts coated using PASTAR UC should be left until dry to the touch in a 25°C environment for 15 to 30 minutes.

If using a PASTAR gun, one spray applies a 0.5 mm thick coating.

PASTAR UWE: Part number V9240 - 0025 PASTAR UC: Spray type: Part number V9240 - 0008

Aerosol type: Part number V9240 - 0021

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment