Transition to the service mode TRAC and Vsc Off mode

The TRAC and VSC systems can be turned off by following the procedures below:

► When using the parking brake and brake pedal:

1) Check that the power source is OFF and the shift lever is in position P.

2) Start the engine after turning the power source ON.

3) Operate the following steps 4 to 8 within 30 seconds of starting the engine.

4) Turn the parking brake switch on.

5) Depress and release the brake pedal twice.

6) Turn the parking brake switch on and off twice while depressing the brake pedal.

7) Depress and release the brake pedal twice while the parking brake switch is on. Notice: Steps 6 and 7 should each be performed within 15 seconds.

8) Check that the slip indicator light and VSC warning light (LE and SE grade models) are turned on or "CHECK VSC SYSTEM" message will appear on the multi-information display (XLE grade models). If not, repeat the procedure from the step 1.

9) The brake control system can be returned to the normal mode by turning the power source ON from OFF.

► When using the hand-held tester:

1) Check that the power source is OFF and the shift lever is in position P.

2) Start the engine after turning the power source ON.

3) Connect the hand-held tester to the DLC3, and operate it to send signals of memory change function.

4) The brake control system can be returned to the normal mode by turning the power source ON from OFF

For details of the transition to service mode, see the 2007 Camry Repair Manual (Pub. No. RM0250U).

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment