Atf Temperature Sensor Onvehicle Repair

1. DISCONNECT SOLENOID CONNECTOR

2. REMOVE LH ENGINE UNDER COVER

3. REMOVE DRAIN PLUG AND DRAIN ATF

4. REMOVE OIL PAN AND GASKET NOTICE:

Some fluid will remain in the oil pan.

Remove the 18 bolts, and carefully remove the oil pan assembly. Discard the gasket.

REMOVE OIL STRAINER

Remove the 3 boits and oii strainer. Remove the O-ring.

6. DISCONNECT 5 SHIFT SOLENOID VALVE CONNECTORS

7. REMOVE ATF TEMPERATURE SENSOR

Remove the bolt and lock plate, and remove the ATF temperature sensor.

8. SEPARATE WIRE HARNESS FROM 2 CLAMPS

9. CLAMP WIRE HARNESS TO 2 CLAMPS

10. INSTALL ATF TEMPERATURE SENSOR

Install the ATF temperature sensor with the lock plate and bolt. Torque: 6.6 Nm (67 kgf-cm, 58 in. lbf)

11. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS

12. INSTALL OIL STRAINER

(b) Install the O-fing to the oil strainer.

12. INSTALL OIL STRAINER

(b) Install the O-fing to the oil strainer.

irii n!

(c) Install the oil strainer with the 3 bolts. Torque: 11 Nm (110 kgf cm, 8 ft.Ibf)

13. INSTALL OIL PAN

Install the oil pan and a new gasket with the 18 bolts. Torque: 7.8 N m (80 kgf cm, 69 in.-lbf)

14. INSTALL DRAIN PLUG Instaif a new gasket and drain plug.

15. CONNECT SOLENOID CONNECTOR

16. FILL ATF AND CHECK ATF LEVEL (See page DI-157)

17. INSTALL LH ENGINE UNDER COVER

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment