Front Axle Hub Components

Drive Shaft

ABS Speed Sensor

Brake Caliper-

—- Tie Rod End Steering Knuckle with Axie Hub

Drive Shaft

Brake Caliper-

Toyota Celica 2000 Steering Knuckle

Lower Ball Joint f103 (1,050, 76)

Lower Ball Joint

J N u: (kyfcm, ft lbf) j : Specified torque N ♦ Non-reusable part

REMOVAL

1. REMOVE FRONT WHEEL

2. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION

(a) Remove the 2 bolts, brake caliper and disc.

(b) Support the brake caliper securely.

Mapa Mundi Para Colorir Escolar1837 Backlash

(c) Using a dial indicator, check the backlash near the center of the axle hub.

If the backlash exceeds the maximum, replace the bearing.

(d) Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.

Maximum: 0.07 mm (0.0028 in.) If the deviation exceeds the maximum, replace the axle hub.

(e) Install the disc, 2 bolts and brake caliper. Torque: 107 N-m (1,090 kgfcm, 79 ft-ibf)

3. REMOVE DRIVE SHAFT LOCK NUT

(a) Using SST and a hammer, unstake the staked part of the lock nut.

SST 09930-00010

(b) While applying the brakes, remove the nut. Torque: 216 N-m (2,200 kgf cm, 159 ft-lbf)

(c) Remove the brake caliper and disc.

(d) Support the brake caliper securely.

REMOVE ABS SPEED SENSOR Torque: 8.0 N-m (82 kgf cm, 71 in.-lbf)

5. LOOSEN 2 NUTS ON LOWER SIDE OF SHOCK ABSORBER

Torque: 153 Nm (1,560 kgf cm, 113 ftlbf)

HINT:

Do not remove the 2 bolts and nuts.

6. DISCONNECT TIE ROD END FROM STEERING KNUCKLE

(a) Remove the cotter pin and nut.

HINT;

At the time of installation, if the holes for a new cotter pin are not aligned, tighten the nut further up to 60°.

Images Sst 09610 20012

(b) Using SST, disconnect the tie rod end from the steering knuckle.

SST 09610-20012

7. DISCONNECT LOWER SUSPENSION ARM FROM LOWER BALL JOINT

Remove the 2 nuts and bolt.

8. REMOVE STEERING KNUCKLE WITH AXLE HUB

(a) Remove the 2 bolts and nuts on the lower side of the shock absorber.

HINT:

At the time of installation, coat the nut's thread with engine oil.

(b) Remove the steering knuckle with (he axle hub. NOTICE:

Be careful not to damage the boot and ABS speed sensor rotor.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • gary
    How to remove celica wheel?
    8 years ago

Post a comment