Input Turbin Speed Sensor Onvehicle Repair

1. REMOVE BATTERY

2. REMOVE ECM AND ECM CASE

3. REMOVE ECM BRACKET

4. REMOVE INPUT TURBIN SPEED SENSOR

(a) Disconnect the connector.

(b) Remove the bolt and input turbin speed sensor.

(c) Remove the O-ring from the input turbin speed sensor.

5. INSTALL INPUT TURBIN SPEED SENSOR

(a) Coat a new O-ring with ATF and install it to the input turbin speed sensor.

(b) Install the input turbin speed sensor with the bolt. Torque: 5.4 Nm (55 kgfcm, 48 in.lbf)

(c) Connect the connector.

6. INSTALL ECM BRACKET Torque:

Bolt: 18 Nm (185 kgf cm, 13 ftlbf) Nut: 12 N m (120 kgf cm, 9 ft lbf)

7. INSTALL ECM AND ECM CASE Torque: 6.9 N m (70 kgf cm, 61 in. lbf)

8. INSTALL BATTERY

ATF TEMPERATURE SENSOR ON-VEHICLE REPAIR

1. DISCONNECT SOLENOID CONNECTOR

2. REMOVE LH ENGINE UNDER COVER

3. REMOVE DRAIN PLUG AND DRAIN ATF

4. REMOVE OIL PAN AND GASKET NOTICE:

Some fluid will remain in the oil pan.

Remove the 19 bolts, and carefully remove the oil pan assembly, Discard the gasket.

5. REMOVE OIL STRAINER

(a) Remove the 3 bolts and oil strainer.

6. DISCONNECT 5 SHIFT SOLENOID VALVE CONNECTORS

7. REMOVE ATF TEMPERATURE SENSOR

(a) Remove the bolt and lock plate, and remove the ATF temperature sensor,

(b) Remove the O-ring from the ATF temperature sensor.

8. INSTALL ATF TEMPERATURE SENSOR

(a) Coat a new O-ring with ATF and it to the direct clutch speed sensor.

(b) install the ATF temperature sensor with the lock plate and bolt.

9. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS

10. INSTALL OIL STRAINER

(b) install the O-ring to the oil strainer.

10. INSTALL OIL STRAINER

(b) install the O-ring to the oil strainer.

(c) Install the oil strainer with the 3 bolts. Torque: 11 N-m (110 kgf-cm, 8 ft-lbf)

11. INSTALL OIL PAN

install the oil pan and a new gasket with the 19 bolts. Torque: 7,8 N-m (80 kgf-cm, 69 in.-lbf)

12. INSTALL DRAIN PLUG install a new gasket and drain plug.

13. CONNECT SOLENOID CONNECTOR

14. FILL ATF AND CHECK ATF LEVEL (See page DI-220)

15. INSTALL LH ENGINE UNDER COVER

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment