Inspection

1. INSPECT INJECTOR INSPECTION CAUTION:

Keep injector clear of sparks during the test.

(a) Purchase the new fuel tube and take out the fuel tube connector from its pipe, P?/t No. 23901-22010

SST

-ij

(Hose)

n--Fuel Tube

Mp] Connector

Fuel Pipe^

^ BÛC-067

(b) Connect SST (hose) and fuel tube connector to the fuel pipe.

SST 09268-41047 CAUTION:

Perform connecting operations of the fuel tube connector (quick type) after observing the precautions.

LI

SST (Hose)

I...VJ J

SST (Union)------

O-Ring-----

3

SST

(Clamp)

Vinyl Tube-----

f

60S96S

(c) Install the grommet and O-ring to the injector.

(d) Connect SST (union and hose) to the injector, and hold the injector to prevent gasoline from splashing out. SST 09268-41047

(e) Put the injector into a graduated cylinder. HINT:

Install a suitable vinyl tube onto the injector to prevent gasoline from splashing out.

(f) Connect the TOYOTA hand-held tester to the DLC3.

(g) Turn the ignition switch ON and TOYOTA hand-held tester main switch ON.

NOTICE:

Do not start the engine.

(h) Select the active test mode on the TOYOTA hand-held tester.

(i) Piease refer to the TOYOTA hand-held tester operator's manual for further details.

SF-23

SFI - INJECTOR_

(j) If you have no TOYOTA hand-held fester, connect the positive (+) and negative (-) ieads from the battery to the fuel pump connector (See page SF-18).

S0MW9

(k) Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times. SST 09842-30080 Volume:

47 - 58 cm3 (2.7-3.3 cu in.) per 15 sec. Difference between each injector: 10 cm3 (0.6 cu in.) or less

If the injection volume is not as specified, replace the injector.

2. INSPECT LEAKAGE

(a) In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.

SST 09842-30080 Fuel drop:

1 drop or less per 12 minutes

(b) Turn the ignition switch to LOCK.

(c) Disconnect the negative (-) terminal cable from the battery.

(d) Remove the SST and fuel tube connector. SST 09268-41047

CAUTION:

Perform disconnecting operations of the fuel tube connector (quick type) after observing the precautions.

As there is retained pressure in the fuel pipe line, prevent it from splashing inside the engine compartment.

(e) Disconnect the TOYOTA hand-held tester from the DLC3.

New Grommet

New Grommet

New O-Rtng
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment