Install Knock Sensor Torque N m kgfcm ft lbf

INSTALL VENTILATION CASE

(a) Install a new gasket and ventilation case with the 3 bolts. Torque: 8.5 Nm (87 kgfcm, 75 in.-lbf)

(b) Install the No. 3 ventilation hose and connect the clip.

25. INSTALL THERMOSTAT (See page CO-11)

Toyota Yaris 2004 Knock Sensor Diagrama

26. INSTALL WATER BYPASS PIPE Torque:

Bolt 8.5 N m (87 kgf cm, 75 In. lbf) Nut 10 N m (100 kgf cm, 7 ftlbf)

INSTALL OIL DIPSTICK AND GUIDE

(a) Install a new O-ring on the dipstick guide.

(b) Apply soapy water on the O-ring.

(c) Connect the dipstick guide end to the main bearing cap.

(d) Install the dipstick guide with the bolt. Torque: 11 N m (113 kgf cm, 8 ft lbf)

28. INSTALL CYLINDER HEAD (See page EM-65)

29. INSTALL ENGINE WIRE

30. INSTALL TIMING SPROCKETS AND TIMING CHAIN (See page EM-25)

31. REMOVE ENGINE STAND

2002 Toyota Celica Flywheel

INSTALL FLYWHEEL

HINT:

The flywheel bolts are tightened in 2 progressive steps, (a) and (c).

(a) Install and uniformly tighten the 8 mounting bolts, in several passes, in the sequence shown. Torque: 49 Nm (500 kgf cm, 36 ft lbf)

(b) Mark the flywheel bolt with paint.

(c) Retighten the flywheel bolts by an additional 90°.

(d) Check that the painted mark in now at a 90° angle to (b).

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • Nadine
    How to install knock sensor celica 2001?
    7 years ago

Post a comment