Onvehicle Repair

1. REMOVE AIR CLEANER ASSEMBLY

2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

3. REMOVE PARK/NEUTRAL POSITION SWITCH

(b) Remove the nut, washer and control shift lever.

IW59Î2

(c) Using a screwdriver, pry off the lock plate.

(d) Remove the nut and lock plate.

(e) Remove the 2 bolts and pull out the park/neutral position switch.

4. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH

(a) Install the park/neutral position switch with the 2 bolts. Torque: 5.4 N-m (55 kgf-cm, 48 in. ibf)

(b) Install a new lock plate and nut. Torque: 6.9 N-m (70 kgf-cm, 61 in. Ibf)

(c) Bend the claws on the lock plate to fix the nut.

(d) install the control shift lever with the nut. Torque: 13 Nm (130 kgfcm, 9 ftlbf)

(e) Connect the shift control cable to the control shaft. Torque: 12 Nm (120 kgf cm, 9 ft lbf)

5. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

6. CHECK PARK/NEUTRAL POSITION OPERATION

Check that the engine can be started with the shift lever only in the N or P position, but not in other position.

If the engine can not be stated not as started above, carry out the adjustment procedure (See page DI-220).

1. INSTALL AIR CLEANER ASSEMBLY

8. TEST DRIVE VEHICLE

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment