Parkneutral Position Pnp Switch

ON-VEHICLE REPAIR

1. REMOVE AIR CLEANER ASSEMBLY

2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

V*

r(H\ H/

ro i vr1 r

1. ! iXs *

i\v

A i A---

> \

i <j

\ \

J*:

h.

3. REMOVE PARK/NEUTRAL POSITION SWITCH

{b} Remove the nut, washer and control shift lever.

(c) Using a screwdriver, pry off the lock plate.

(d) Remove the nut and lock plate.

Celica Pnp Switch

(e) Remove the 2 bolts and pull out the park/neutral position switch.

4. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH

(a) Install the park/neutral position switch with the 2 bolts. Torque: 5.4 N m (55 kgfcm, 48 in.lbf)

(b) Install a new lock plate and nut. Torque: 6.9 N m (70 kgf cm, 61 In. lbf)

(c) Bend the claws on the lock piate to fix the nut.

(d) Install the control shift lever with the nut. Torque: 13 N m (130 kgfcm, 9 ft-lbf)

(e) Connect the control cable to the control shaft. Torque: 12 N-m (120 kgf cm, 9 ft ibf)

5. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

6. CHECK PARK/NEUTRAL POSITION OPERATION

Check that the engine can be started with the shift lever only in the N or P position, but not in other position. If the engine can not be stated not as started above, carry out the adjustment procedure (See page Dl—157).

7. INSTALL AIR CLEANER ASSEMBLY

8. TEST DRIVE VEHICLE

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment