Place Connecting Rod Cap On Connecting

(a) Match the numbered connecting rod cap with the connecting rod.

(b) Align the pin dowels of the connecting rod cap with the pins of the connecting rod, and install the connecting rod.

Front*

Front*

HINT:

HINT:

Check that the protrusion of the connecting rod cap is facing in the correct direction. INSTALL CONNECTING ROD CAP BOLTS

The connecting rod cap bolts are tightened in 2 progressive steps (steps (b) and (d)).

If any of the connecting rod cap bolts is broken or deformed, replace it.

Apply a light coat of engine oil on the threads and under the heads of the connecting rod cap bolts. Install and alternately tighten the 2 connecting rod cap bolts in several passes. Torque:

1ZZ-FE: 20 Nm (204 kgfcm, 15 ftlbf) 2ZZ-GE: 30 Nm (306 kgfcm, 22 ft lbf)

if any of the connecting rod cap bolts does not meet the torque specification, replace the connecting rod cap bolts.

(c) Mark the front of the connecting cap bolts with paint.

(d) Retighten the cap bolts by 90° as shown.

(e) Check that the painted mark is now at a 90° angle to the front.

(f) Check that the crankshaft turns smoothly.

14. CHECK CONNECTING ROD THRUST CLEARANCE (See page EM-98)

15. INSTALL REAR CRANKSHAFT OIL SEAL (See page EM-104)

HINT:

Wipe seal packing away from the contact surface of the cylinder block assembly and oil seal.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment