Removal

1. REMOVE REAR WHEEL

2. REMOVE TAILPIPE AND HEAT INSULATOR

(a) Remove the 2 bolts, springs, gasket, 3 O-rings and tailpipe.

(b) Remove the 4 bolts and heat insulator.

3. REMOVE STABILIZER BAR LINKS

(a) Remove the 2 nuts and stabilizer bar link. Torque: 44 N-m (449 kgf-cm, 32 ft lbf)

HINT:

If the ball joint turns together with the nut, use a hexagon (5 mm) wrench to hold the stud.

(b) Employ the same manner described above to the other side.

! F0865S

4, REMOVE STABILIZER BAR BRACKETS AND BUSHINGS

(a) Remove the 2 bolts, bracket and bushing. Torque: 18 N-m (184 kgf-cm, 13 ft lbf)

HINT:

At the time of installation, install the bushing to the outside of the stopper on the stabilizer bar.

(b) Employ the same manner described above to the other side,

5. REMOVE STABILIZER BAR

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment