Y w

21. REMOVE 4 BOLTS AND DISCONNECT PS GEAR ASSEMBLY

HINT:

Support the PS gear assembly securely.

22. REMOVE SUSPENSION MEMBER

(a) Remove the 9 bolts arid 3 nuts. Torque:

Bolt A: 157 N-m (1,601 kgf cm, 116 ft-lbf) Bolt B: 52 N m (530 kgfcm, 38 ft-lbf) Bolt C: 39 N m (398 kgf cm, 29 ft-lbf) Nut: 52 N m (530 kgf cm, 38 ft-lbf)

(b) Remove the suspension member.

23. REMOVE ENGINE REAR MOUNTING INSULATOR

Remove the bolt and engine rear mounting insulator. Torque: 87 N m (890 kgf cm, 64 ft-lbf)

24. ATTACH ENGINE SLING DEVICE TO ENGINE HANGERS

(a) Disconnect the 2 PCV hoses.

(b) Install the No. 1 and No. 2 engine hangers in the correct direction.

No. 1 engine hanger: 12281-88600 No. 2 engine hanger: 12282-88600 Bolt: 91512-61020

(c) Attach the engine chain hoist to the engine hangers. CAUTION:

Do not attempt to hang the engine by hooking the chain to any other part.

^JA

V

-C\\

/

25. REMOVE UPPER SIDE ENGINE LEFT MOUNTING, NUT AND BOLT

26. REMOVE OIL COOLER HOSE

Loosen the 2 clips and disconnect the 2 oil cooler hoses.

27. SUPPORT TRANSAXLE WITH A JACK

c<.

y,

\ -V

28. REMOVE TORQUE CONVERTER CLUTCH MOUNTING BOLT

Turn the crankshaft to gain access and remove the 6 bolts holding the crankshaft pulley set bolt with a wrench. Torque: 41 N m (418 kgf-cm, 30 ftlbf)

HINT:

At the time of installation, please refer to the following item. First install black colored bolt and then 5 other bolts.

29. REMOVE TRANSAXLE ASSEMBLY

(a) Remove the 4 bolts. Torque:

A bolt: 46 N m (470 kgi-cm, 34 ftlbf) B bolt: 23 N-m (230 kgf-cm, 17 ft lbf)

(b) Separate the transaxle from engine, and lower the trans-axle.

AUTOMATIC TRANSAXLE (U24QE) - AUTOMATIC TRANSAXLE UNIT ___

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment