ZZFE Nm kgfcm ft ibf ZZGE Nm kgf cm ft lbf

If any one of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.

(c) Mark the front of the cylinder head bolt with paint.

Retighten the cylinder head bolts 90" in the numerical order shown.

Retighten the cylinder head bolts 180° in the numerical order shown.

Check that the paint mark is not at a 90° angle to the front.

2ZZ-GE:

Check that the paint mark is not at a 180" angle to the tront.

(h) install the bolt holding the water bypass pipe to the cylinder head.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment