Check Vacuum Circuit Continuity In Vsv By Blowing Air Into Pipe

(a) Connect the VSV terminals to the battery terminals as shown.

(b) Blow into pipe "A", and check that air comes out of pipe "B"

but does not come out of filter "C".

(c) Disconnect the battery.

(d) Blow into pipe "A" and check that air comes out of filter

"C" but does not come out of pipe "B". If a problem is found, replace the VSV.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment