Clean And Shape Contact Surface Of Body

(a) Remove the retainers.

(b) Remove any dam remaining on the body.

(c) Cut away any rough areas with a knife.

HINT: Leave as much of the urethane layer on the body as possible.

(d) Clean the cutting surface of the urethane gum with a piece of shop rag saturated in cleaner.

HINT: Even if all the urethane has been removed, clean the body.

2. CLEAN REMOVED GLASS BEFORE INSTALLATION

(a) Using a scraper, remove the urethane gum sticking to the glass.

(b) Clean the glass with cleaner.

NOTICE: Do not touch the glass after cleaning it.

3. POSITION GLASS

(a) Place glass in correct position.

(b) Check that all contacting parts of the glass rim are perfectly even and do not make contact with the fasteners.

(c) Place reference marks between the glass and body.

(d) Remove the glass.

4. CLEAN CONTACT SURFACE OF GLASS

Using cleaner, clean the contact surface black-colored area around the entire glass rim.

NOTICE: Do not touch the glass face after cleaning it.

7nun

7nun

5. INSTALL DAM

Install the dam with double-sided tape as shown in the drawing.

NOTICE: Do not touch the glass face after cleaning it.

6. COAT CONTACT SURFACE OF BODY WITH PRIMER

Using a brush, coat the contact surface on the body with

Primer M.

NOTICE:

• Let the Primer coating dry for 10 minutes or more. Make sure that the installation of the glass is finished within 2 hours.

• Use care not to leave any part of the contact surface un-coated or excessively coated, as Primer M and G serve to boost the adhesive power of the urethane to the glass or body.

• Do not keep any of the opened Primer M and G for later use.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment