Diagnostic Chart

1

Preparation.

2

Does airbag warning light turn off after approx. 10 seconds?

Check battery and charging system (See page CH-2).

Check diagnostic code, and if a malfunction code is output, perform troubleshooting according to malfunction code. If a norma code is output, replace center air bag sensor assembly.

WIRING DIAGRAM

Ignition SW

Center Arbag Sensor Assembly

Ignition SW

Center Arbag Sensor Assembly

Bettery

INSPECTION PROCEDURE

Q| Preparation HCheck

Preparation.

Center Airbag Senear Assembly

Center Airbag Senear Assembly

nJCi't UOOfS

(1) Turn ignition switch LOCK.

(2) Disconnect center airbag sensor assembly connector.

(3) Turn ignition switch ON. But do not start en gine.

(4) Measure voltage at IGi, IG2 or ACC on con nector wire harness side of center airbag sensor assembly and operate electric system (defogger, wiper, headlight, heater blower, etc.).

(5) Turn electric system switch OFF.

(6) Turn ignition switch LOCK.

(7) Remove voltmeter and connect center airbag sensor assembly connector.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment