Disconnect the pin connector from the relay and inspect the connector on wire harness side as shown in the chart

Check for

Tester connection

Condition

Specified value

Continuity

1 - Ground

Constant

*' Continuity

4 - Ground

2 - 7

Headlight position

Any position ex. uppermost

——

Continuity

*»5-7

Uppermost

No continuity

"¿-11

Headlight position

Any position ex. lowermost

Continuity

+I5 - 11

Lowermost

No continuity

6 - Ground

Light control switch position

OFF or HEAD

No continuity

HOLD or TAIL

Continuity

12 - Ground

Constant

Continuity

Voltage

3- Cfflund

Constant

Battery voltage

3 - Ground

Light control switch position: OFF, HOLD or TAIL

Headlight dimmer switch position

Low beam or High beam

Battery voltage

Flash

No voltage

Light control switch position: HEAD

No voltage

*': There is resistance because this circuit is grounded through the motor.

*2: Connect the test leads so that the current from the ohmmeter can flow according to the above orders.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment