Hazard Warning Switch Continuity

tj"

1 1

1

U=U

2

] 1

ID

&

H

7

t

E ■

—.

Terminal

4

5

G

7

fi

s

lIllllllillHliLH',

Switch position

2

3

OFF

-j

ON

o-

-0

If continuity is not as specified, replace the switch. 2. INSPECT TURN SIGNAL FLASHER (Operation)

(a) Connect the positive (+) lead from the battery to terminal 2

and the negative (-) lead to terminal 3.

(b) Connect the two turn signal light bulbs parallel to each other to terminals 1 and 3, check that the bulbs flash. HINT: The turn signal lights should flash 60 to 120 times per minute.

If one of the front or rear turn signal lights has an open circuit, the number of flashers will be more than 140 per minute. If operation is not as specified, replace the flasher.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment