Clutch Switch Circuit with MT

HINT: While carrying out the following inspection, make certain that the connectors and terminals are properly connected. CLUTCH SWITCH


Is clutch switch installed properly? ,_

Reinstall clutch switch properly. Then recheck system.

Disconnect connector from clutch switch and inspect connector on wire harness side as follows.

CC: Cruise Control

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment