Installation Of Condenser

1. INSTALL CONDENSER

Install the four condenser nuts, making sure the rubber cushions fit on the mounting flanges correctly.

2. CONNECT LIQUID TUBE, DISCHARGE HOSE TO

CONDENSER Torque:

Liquid tube 140 kg-cm (10 ft-Ib, 14 N-m) Discharge hose 230 kg-cm (17 ft-Ib, 23 N-m)

3. INSTALL CONDENSER FAN

4. INSTALL CENTER BRACE AND HORNS

5. INSTALL FRONT GRILLE AND UNDER COVER

6. IF CONDENSER WAS REPLACED, ADD

COMPRESSOR OIL TO COMPRESSOR Add 40 - 50 cc (1.4 -1.7 fl.oz.) DENSOOIL 6,

SUNISO No. 5GS or equivalent.

7. EVACUATE AIR FROM AIR CONDITIONING SYSTEM

8. CHARGE AIR CONDITIONING SYSTEM WITH

REFRIGERANT AND CHECK FOR GAS LEAKAGE Specified amount 720 ± 50 g (25.4 ± 1.8 oz)

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment