Installation Of Cooling Unit

1. INSTALL COOLING UNIT

Install the cooling unit with three nuts and four bolts.

2. CONNECT CONNECTORS

3. INSTALL GLOVE BOX AND REINFORCEMENT

4. INSTALL GROMMETS ON INLET AND OUTLET

FITTINGS

5. CONNECT LIQUID TUBE TO COOLING UNIT INLET

FITTING

Torque the nut.

6. CONNECT SUCTION TUBE TO COOLING UNIT

OUTLET FITTING

Torque the nut.

7. IF EVAPORATOR WAS REPLACED, ADD

COMPRESSOR OIL TO COMPRESSOR Add 40 - 50 cc (1.4 -1.7 fl.oz.) DENSOOIL 6,

SUNISO No. 5GS or equivalent.

8. CONNECT NEGATIVE CABLE TO BATTERY

9. EVACUATE AIR FROM AIR CONDITIONING SYSTEM

10. CHARGE AIR CONDITIONING SYSTEM WITH

REFRIGERANT AND CHECK ON GAS LEAKAGE Specified amount: 720 ±50 g (25.4 ±1.8 oz)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment