Installation Of Outside Moulding

1. CLEAN MOULDING MOUNTING SURFACE

Wipe off stains with cleaner.

MZ232

2. HEAT BODY MOUNTING SURFACE

Using a heat light, heat the body mounting surface to 30

NOTICE: When the moulding is installed, the temperature of the mounting surface should be 20°C (68°F) or higher.

3. HEAT MOULDING

Using a heat light, heat the moulding to 30 - 60°C (86 -140°F).

NOTICE: Do not heat moulding excessively.

The temperature should not be higher than 80°C (176 °F).

4. COAT MOULDING WITH PRIMER "T"

Using a brush, coat both of the punched out ends of the moulding with Primer T.

NOTICE:

• Let the Primer T dry for 30 seconds or more.

• Do not touch the Primer T coating.

5. APPLY ADHESIVE TO MOULDING

Apply adhesive to both punched out ends of the moulding.

NOTICE: Install the moulding within 7 minutes after applying the adhesive.

6. LIFT MOULDING RELEASE SHEET FROM FACE OF MOULDING

NOTICE: When the moulding release sheet is removed, be sure that no dirt or dust can get onto the uncoated area.

7. INSTALL MOULDING ALONG BODY PRESS LINE

HINT: Before installing the moulding, remove the backing paper on the edge of the moulding. Align the bosses on the moulding with the body holes, and push the moulding to the body. NOTICE:

• Be sure that the body and moulding are heated to the proper temperature.

• Do not depress the adhesive-coated parts excessively just hold them down with your thumb.

• Scrape off any overflowing adhesive with a plastic spatula and clean the surface with a dry rang.

• After installation, do not wash the vehicle for 24

hours.

A ■ 1 2 mm {0 0472 in.) B : Ijfl rum fO.O630 in ) C : 1 6 mm {0Q?ü9 ¡n.>

KUNS

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment